8/8/2017 | 1 MINUTE READ

Cylinder Coating for Improved Performance

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Generally, when OEMs produce aluminum engine blocks (aluminum rather than cast iron because cast iron weighs like cast iron), they insert sleeves into the piston bores—cast iron sleeves.

Share

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Generally, when OEMs produce aluminum engine blocks (aluminum rather than cast iron because cast iron weighs like cast iron), they insert sleeves into the piston bores—cast iron sleeves. But not all vehicle manufacturers are doing this.

Daimler, in particular, as it worked in cooperation with Heller Machine Tools to develop an arc spraying process for coating cylinder bore surfaces (and aluminum crankcases) with a process they’re calling “NANOSLIDE.”

This year the company is using it in production of approximately one-million 4- and 6-cylinder engines per year at its facilities in Untertürkheim. (And other OEMs, including Renault and Nissan—which, not coincidentally, are working with Mercedes on engines—are using the process, as well.

OM 642 - NANO SLIDE (LDS)

The process works by melting iron/carbon wires that are lowered into the bore and then a nitrogen gas flow propels the melted particles (which are as hot as 2000° C) at a velocity of 60 to 80 m/sec.

While the process has been long used for small volumes—Daimler has been working on the process since 1998, when it was using it for AMG engines—Heller has “productionized,” in effect, the process, which it calls “CBC,” for Cylinder Bore Coating.

This is an entire process that is performed on a Heller MC20 machining center.

Entire, as in fine boring, roughening (texturing the surface for the spray), coating, rough honing, finish honing, and finish machining. According to the company the entire process—including block load/unload—can be performed on an eight-cylinder engine within six minutes. Once the coating is applied, an optical sensor, a Jenoptik IPS 100 bore inspector, is lowered into the cylinder and provides a 360° look at the condition of the surface, including any defects or porosities.

So what does this do for an engine?

It is lighter than a liner. Given the frictional characteristics of the surface, it helps improve engine performance, which contributes to better fuel economy. It helps reduce wear in engines over time.

OM 642 - NANO SLIDE (LDS)


RELATED CONTENT

  • Breaking Down the Chevy Bolt

    Sandy Munro and his team of engineers and costing analysts at Munro & Associates were contacted by UBS Research—an arm of the giant banking and investment firm—and asked whether it was possible to do a teardown and cost assessment of the Chevrolet Bolt EV.

  • Do Plastic Body Panels Have A Future?

    Remember those Saturn commercials showing shopping carts bouncing harmlessly off of plastic body panels? Good idea, right? But apparently the approach never really caught on. Now the question is: will it ever?

  • Chip Foose: Humble Genius

    Scene 1After speaking at Detroit's Cobo Hall during the North American International Auto Show, Chip Foose seems genuinely taken with the evident adulation of the audience, and takes the time to answer every question and sign autographs.The second oldest child and only male in a family with four kids, Chip Foose was born in Santa Barbara, California, on October 6, 1963.

Resources