4/3/2019 | 1 MINUTE READ

Nanoparticles Advance Aluminum Alloy Welding

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Aluminum alloy AA 7075 is almost as strong as steel but weighs only a third as much—a dream material to use for lightweighting, you might think.

Share

Facebook Share Icon LinkedIn Share Icon Twitter Share Icon Share by EMail icon Print Icon

Aluminum alloy AA 7075 is almost as strong as steel but weighs only a third as much—a dream material to use for lightweighting, you might think. And in the decades since it was developed in the 1940s it has seen use in airplane wing skins because it can be riveted. But its use in other industries has been curtailed by the fact that the same molecular structure that gives it a great strength-to-weight ratio has also made it notoriously difficult to weld. Until now, that is.

The problem is that when the alloy is heated during welding, its constituent elements—aluminum, zinc, magnesium and copper—flow unevenly, melting and resolidifying at different rates, which results in cracks along the weld.

Researchers at the UCLA Samueli School of Engineering (samueli.ucla.edu) have now found a way to weld the alloy using traditional arc welder technology.

Their solution: infusing titanium carbide nanoparticles into AA 7075 welding rods, which are then used as the filler material between the pieces being joined. The presence of the nanoparticles causes the liquified alloy’s elements to solidify together much more uniformly as it cools, eliminating cracks.

Using this approach, the researchers produced welded joints with a tensile strength of 392 megapascals (MPa). By comparison, the widely used aluminum alloy AA 6061 has a tensile strength of 186 MPa in welded joints. The researchers posit that post-welding heat treatments could further increase the strength of AA 7075 joints—up to 551 MPa, which is comparable to steel. The team has published their findings in the journal Nature Communications (nature.com).

“The new technique is just a simple twist, but it could allow widespread use of this alloy in mass-produced products like cars or bicycles,” said UCLA professor of manufacturing Xiaochun Li, the study’s principal investigator. “Companies could use the same processes and equipment they already have to incorporate this alloy into their manufacturing processes, and their products could be lighter and more energy efficient, while still retaining their strength.”

RELATED CONTENT

  • Breaking Down the Chevy Bolt

    Sandy Munro and his team of engineers and costing analysts at Munro & Associates were contacted by UBS Research—an arm of the giant banking and investment firm—and asked whether it was possible to do a teardown and cost assessment of the Chevrolet Bolt EV.

  • Jeeps Modified for Moab

    On Easter morning in Moab, Utah, when the population of that exceedingly-hard-to-get-to town in one of the most beautiful settings on Earth has more than doubled, some people won’t be hunting for Easter eggs, but will be trying to get a good look at one of the vehicles six that Jeep has prepared for real-life, fast-feedback from the assembled at the annual Easter Jeep Safari.

  • We Can’t Unwatch this McLaren

    While we generally can’t say enough (which brings us close to saying much, much too much) about McLaren Automotive design and its exquisite use of materials, this week the company launched a product that is something we wish we didn’t see: That’s the RM 11-03 McLaren Automatic Flyback Chronograph, which the company debuted at the 88th Geneva International Motor Show.